Browse Products
  • Add description, images, menus and links to your mega menu

  • A column with no settings can be used as a spacer

  • Link to your collections, sales and even external links

  • Add up to five columns

  • Waterfurnace Geothermal 30x36x2 MERV 10 Powerguard Air Filter (4PK)

    This PowerGuard filter replaces the Airguard filters that are no longer available for WaterFurnace and is considered as an acceptable replacement MERV 10 air filter for all their Geothermal Comfort Systems that use an "exact" size 30 x 36 x 2 pre-filter.  

    The replacement filters used with WaterFurnace units that use a 30 x 36 x 2 pre-filter must use a filter that is a full 30" x 36".  If you use a smaller filter such as many of the 29 1/2" x 35 3/4" filters sold by typical manufacturers, your filter will not seal properly and you could get unfiltered air leaking bypass around the edges of the filter.

    This MERV 10 air filter is approximately 30" x 36" x 1 3/4" and is the size recommended by WaterFurnace for a proper fit. 

    Common WaterFurnace Geothermal Heat Pump Models
    that use the 30 x 36 x 2 MERV 10 pre-filter:

    Envision Series:
    Single Speed Vertical Units: NDV060, NDV070
    Dual Capacity Vertical Units: NDV064, NDV072

    Legend Series:
    Vertical Units: LSV070

    Premier Series:
    Vertical Units: P040, P046, P056, P066

    The PowerGuard filter is made of 100% synthetic fibers that are needled together and then electro statically charged.  The needled fibers create a dense mat that produces a MERV 10 rating and higher mechanical efficiency at a lower air resistance than other pleated filters. WaterFurnace Premier Series units have an air filter rack that can be set for 1" or 2" when the units are installed.  In most situations you will not be able to change your units filter rack size without altering your ductwork, so please make sure your unit's filter rack is set for 2" filters. 

    All WaterFurnace units that use a 30 x 36 x 2 air filter, actually use two 18 x 30 x 2 filters stacked - taped together, folded for less damage.

    You will need to add a piece of tape to complete the joining.  

    The manufacturer suggested replacement interval is 4 to 6 months, We suggest using a Sharpie to date the filter when you replace it. Depending upon conditions and lifestyle, you may need to replace this filter more or less frequently.

    For instructions on how to change your furnace's air filter, please refer to your unit's Owner's Manual.

    This package ships with 4 filters and are NOT returnable - Please make sure you are ordering the proper size.

     

    WARNING: Shipping on this filter pack is expensive because of the size - PLEASE make sure your filters arrive in good condition - once is ships, it's your responsibility & damages must be reported to the shipper immediately!