Waterfurnace Geothermal 30x32x2 MERV 10 PowerGuard Air Filter (4PK)
The PowerGuard for WaterFurnace and is considered by WaterFurnace to be the OEM replacement MERV 10 air filter for all their Geothermal Comfort Systems that use a 30x32x2 pre-filter. Two 16x30x2 filters are typically "taped" together, just like the factory filters. The MERV11 version has been discontinued.
The replacement filters used with WaterFurnace units that use a 30 x 32 x 2 pre-filter must use a filter that is a full 32" x 30". If you use a smaller filter, such as many of the 31 1/2" x 29 3/4" filters sold by other manufacturers, your filter will not seal properly, and you could get unfiltered air leaking around the edge of the filter, this is called bypass.
The PowerGuard MERV 10 air filter is approximately 30" x 32" x 1 3/4" and is the size recommended by WaterFurnace for a proper fit.
Common WaterFurnace Geothermal Heat Pump Models
that use the 30 x 32 x 2 MERV 10 pre-filter:
Envision Series:
Single Speed Vertical Units: NDV036
Dual Capacity Vertical Units: NDV038
Legend Series:
Vertical Units: LSV042, LSV048
The manufacturer suggested replacement interval is 4 to 6 months, depending upon conditions and lifestyle. A Pack of 4 should last one to two years.
For instructions on changing your furnace's air filter, please refer to your unit's Owner's Manual.
This package ships with 4 filters. These filters are NOT returnable due to the shipping costs and high potential for shipping damage. We ship these direct to you. Please inspect the package for damage. PLEASE make sure this is correct before we ship.Once ordered, we can't cancel or refund your payment.
$324.95